Radius Server configuration on B3 Series Switches

  • 0
  • 2
  • Problem
  • Updated 5 months ago
  • Solved
Dear all,

I configured a B3 Enterasys switch (with the latest firmware on it B3-661100008) for MAC authentication purpose via a RADIUS Server (Ip address 100.1.3.59).

I used the following commands:

set radius server 1 100.1.3.59 1812 Password realm network-access
set radius enable
set macauthentication enable
set macauthentication password Password
set macauthentication port enable *.*.*
set macauthentication portquietperiod 60 *.*.*

The problem is that the switch is not sending any authentication request to Radius Server, tested with tcpdump and wireshark, even if ping the connectivity between them is ok. I used the same configuration on a C5 Enterasys switch and it works!

Somebody could kindly help me?

Thank you in advance
Best Regards
Claudio Minnetti
Photo of Claudio Minnetti

Claudio Minnetti

  • 164 Points 100 badge 2x thumb

Posted 5 years ago

  • 0
  • 2
Photo of Jason Parker

Jason Parker, Employee

  • 2,908 Points 2k badge 2x thumb
Official Response
Here is one that is working for me on a C5
Jason

#radius
set radius enable
set radius server 1 10.58.196.5 1812 mysecret realm any

set dot1x enable
set eapol enable
set eapol auth-mode auto ge.1.1
set eapol auth-mode forced-auth ge.1.24

#multiauth
set multiauth port mode auth-opt ge.1.1
set multiauth port mode force-auth ge.1.1
set multiauth precedence dot1x mac pwa
set multiauth mode multi

#macauthentication
set macauthentication password password
set macauthentication port enable ge.1.1
set macauthentication enable