cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Rate limit and max burst size

Rate limit and max burst size

Sarah_Seidl
New Contributor III
Hello everyone,
We have a WAN circuit that is 100 MB "best effort" (ie not real time or priority) by our provider. We're seeing dropped packets on the WAN interface on our core stack. I opened a case with our provider and they are saying that we are exceeding our policers. That our traffic isn't being shaped correctly and we are sending them data "too fast" They said our burst rate by their calculation should be set to 1,280 kb for our circuit.

So I was trying to see if this would be the proper syntax?

conf port 4:1 rate-limit egress 95 Mbps max-burst-size 1280 Kb

Thinking that the egress should be 95% of the pipe of 100 MB and the burst size what they recommended.

Does that look okay?

Thanks,
Sarah
6 REPLIES 6

Sarah_Seidl
New Contributor III
Thanks for the added info. I'll keep an eye on utilization too. And am definitely seeing dropped packets (sh port congestion) incrementing.

StephenW
Extreme Employee
If, you check "show port utilization" it's only going to give you an average over 5 seconds. If the traffic is bursty it will not always show high utilization. Port congestion like EtherMAN suggested is a great indicator of an over utilized port for egress.

Sarah_Seidl
New Contributor III
100 MB for the guaranteed bandwidth (they said we were overutilizting that), the hand off is 100 MB as well
Thank you

Thanks again for the reply. So I am indeed seeing dropped packets on the port that connects to the service providers equipment from our extreme switch (xos). This made me open a ticket with them to check things out.
GTM-P2G8KFN