cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Replacing MSM: Software incompatible

Replacing MSM: Software incompatible

craymond
New Contributor III
We replaced an MSM on a BD8810. When we first installed it, It upgraded firmware and then came online. We had though that it had just installed new firmware to the new card and it was working as expected. However, now I have noticed that it actually pushed the updated firmware to the primary (currently unused) partition on the working MSM and now MSM-A and MSM-B have different firmware. The active MSM is using the secondary image at 12.2.2.7 (primary = 12.5.4.5), while the inactive MSM has both images at 12.5.4.5. If the active MSM fails will it now reboot because the images are incompatible?
6 REPLIES 6

Paul_Russo
Extreme Employee
Hello Craymond

Sync makes the two MSMs exactly the same without having to connect to a TFTP server and uploading and downloading the files to and from the MSMs.

You absolutely can download the code to the other MSM if you like with no issues.

Thanks
P

Drew_C
Valued Contributor III
Were you able to get everything sorted out with the info here in the thread?
Got both MSMs In Sync and all versions sorted out? Here's an example from one of my lab cores.
# show switch

SysName:
SysLocation:
SysContact:
System MAC:
System Type: BD-8806

SysHealth check: Enabled (Normal)
Recovery Mode: All
System Watchdog: Enabled

Current Time: Thu Jul 30 15:18:22 2015
Timezone: [Auto DST Enabled] GMT Offset: -300 minutes, name is EST.
DST of 60 minutes is currently in effect, name is not set.
DST begins every second Sunday March at 2:00
DST ends every first Sunday November at 2:00

Boot Time: Wed Nov 19 06:08:15 2014
Boot Count: 47
Next Reboot: None scheduled
System UpTime: 253 days 8 hours 10 minutes 31 seconds

Slot: MSM-A * MSM-B
------------------------ ------------------------
Current State: MASTER BACKUP (In Sync)

Image Selected: primary primary
Image Booted: primary primary
Primary ver: 15.4.2.8 15.4.2.8
patch1-3 patch1-3
Secondary ver: 15.4.1.3 15.4.1.3

Config Selected: primary.cfg primary.cfg
Config Booted: primary.cfg primary.cfg

primary.cfg Created by ExtremeXOS version 15.4.2.8
578077 bytes saved on Thu Jul 9 14:40:06 2015

craymond
New Contributor III
Thanks for the info.

OscarK
Extreme Employee
The Synchronize command is just designed for this purpose, it syncs the backup MSM with the active MSM to have the same software versions and files (like policy files and so on).
GTM-P2G8KFN