Ridgeline 4.0 SP1

  • 0
  • 1
  • Problem
  • Updated 2 years ago
  • Solved
Hi, I have a problem with adding device to the Ridgeline. Attempt to add the device fails with the error: "SNMP connection failure in fetching system oid. Please check SNMP credentials and route to the switch.". What am I doing wrong? Can you help me?
Photo of bula

bula

  • 80 Points 75 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of Paul Russo

Paul Russo, Alum

  • 9,694 Points 5k badge 2x thumb
Hello Bula.

There is a second SP that you would also load. Early version of Ridgeline had some bugs. Not sure if this is one of them but would be good to have it loaded.

Are you using the default SNMP strings on the switch?

P
Photo of bula

bula

  • 80 Points 75 badge 2x thumb
Hello Paul, thank you for reply. Yes, I am using default SNMP string on the switch. 
(Edited)
Photo of Sumit Tokle

Sumit Tokle, Alum

  • 5,738 Points 5k badge 2x thumb
Which device are you trying to add? What SNMP protocol are you using to add the devices?

 I have seen this issue before when we are trying to add Wireless controller.

or else there could be some configuration issue. If you have any device which was already added in RL then I would suggest to compare SNMP configuration on both devices(added and unable to add)
Photo of Abhishek Potdar

Abhishek Potdar

  • 140 Points 100 badge 2x thumb
Was there a resolution for this issue? I have Ridgelien 4.0 SP2 and getting the same error message. Tried SNMPv1 and SNMPv3 with the correct snmp config still unable to add
Photo of Marlon

Marlon

  • 1,570 Points 1k badge 2x thumb
hi,

pleas try to execute the command below then try to add again the switch to ridgeline

configure snmpv3 add mib-view defaultUserView subtree 1 type included
configure snmpv3 add mib-view defaultAdminView subtree 1 type included
configure snmpv3 add mib-view defaultNotifyView subtree 1 type included
Photo of Abhishek Potdar

Abhishek Potdar

  • 140 Points 100 badge 2x thumb
Hey Marlon,

No luck, I tried the commands you listed above. Thanks for your help
Bula, You find the solution?
Photo of Fauriant Tristan

Fauriant Tristan

  • 384 Points 250 badge 2x thumb
I had the same issue on a 2 * x460 stacked node in version 15.5.3.4 p1-2 and with the three commands above the Ridgeline node integration is ok now.
My version of Ridgeline : 4.0 SP1.