This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

S-Series hard coded port isn't working

S-Series hard coded port isn't working

Matt_Dillion
New Contributor III

‎07-24-2018 04:23 PM

After hard coding a port on my S-Series S1 switch the port will not work. I have hard coded the port using the following commands in order; set port duplex ge.1.46 full, set port speed ge.1.46 1000, set port negotiation ge.1.46 disable. I have tried using multiple pieces of equipment but the port never comes up.
0 Kudos
3 REPLIES 3

Matt_Dillion
New Contributor III

‎07-25-2018 01:17 PM

Well, I received an email update from Extreme notifying me that Curtis Parish replied to my problem, however I do not see that reply here. Nevertheless, if you are reading this Curtis, I disabled negotiation on the port in question. Command executed "set port negotiation ge.1.46 disable".
0 Kudos

Matt_Dillion
New Contributor III

‎07-25-2018 10:11 AM

When using my laptop I have tried manually setting the speed/duplex setting to 1000/Full. I have also tried creating a loop and tried plugging the port into another Enterasys switch with the port set to auto-negotiate.
0 Kudos

Zdeněk_Pala
Extreme Employee

‎07-24-2018 08:21 PM

What is on the other end? How it is configures? Before your changes, was there a link? If you create loop (with spanning tree enabled by default) do you get link?
Regards Zdeněk Pala
0 Kudos
GTM-P2G8KFN