S-Series Reports "Dune[x.dTcmTask]FAP 0" Errors

  • 0
  • 1
  • Article
  • Updated 5 years ago
  • (Edited)
Article ID: 12603 

Products
S-Series 

Symptoms
Possible module reset.
"Dune[<slot>.dTcmTask]FAP 0" errors visible in the output of a 'show support'. 

For example: 
Message   5/73   Syslog Message            07.01.03.0004   11/11/2009 10:57:48
<0>Dune[3.dTcmTask]FAP 0, slot 3 detects a recoverable error FAP21V_MMU_
PDC_SYNC_ERR(2). However, maximum number of auto-recovery is exceeded.
Board is reset. ( 0x00cb98c4 0x0171fce0 0x018182f8 0x0196abb4 0xeeeeeeee )

Message 6/73 Syslog Message 07.01.03.0004 11/11/2009 10:57:48
<3>Dune[3.dTcmTask]FAP 0, slot 3 detects a recoverable error FAP21V_MMU_
CRC_ERR(2) ... auto-recovery.
Cause
The Fabric Adapter (FAP) is detecting errors. 

Solution
Please contact the GTAC for assistance.
Photo of FAQ User

FAQ User, Official Rep

  • 13,610 Points 10k badge 2x thumb

Posted 5 years ago

  • 0
  • 1

There are no replies.

This conversation is no longer open for comments or replies.