S-Series with "Fuji RX MAIN" errors seen in the Logs

  • 0
  • 1
  • Article
  • Updated 5 years ago
  • (Edited)
Article ID: 13512 

Products
S-Series 

Symptoms
"FUJI RX MAIN" errors seen in the 'show support' output's logging buffer and messageLog sections. 

For example:
<163>Oct 22 21:43:48 10.1.232.7 Fuji[1.tNimIntr]Fuji RX MAIN intr:
Fuji=0, Adr=0, Reg=0x00200040
<163>Oct 22 21:44:55 10.1.232.7 Fuji[1.tNimIntr]Fuji RX MAIN intr:
Fuji=0, Adr=0, Reg=0x00200040
This is not known to cause performance issues. 

Solution
Upgrade to firmware 7.21.02.0002 or higher.
Release notes state, in the 'Firmware Changes and Enhancements' section:
Platform
If ports are receiving traffic while their MAC chip is being initialized the MAC may mishandle these packets and cause errors similar to "1. Fuji RX MAIN intr: Fuji=8, Adr=0, Reg=0x00200040", "2. Fuji MAC MAIN intr: Fuji=0, Adr=0, Reg=0x00080000", "3. MEM_FAIL interrupt occurred on chip" (which resets blade), or one of several bcmstrat memory system parity errors sometimes reported as "bcmStrat[3.bcmDPC]unit 0 (null) asserted ". The "parity" and "null" messages are displayed constantly and result in high CPU utilization.

If the issue persists after upgrade, please contact the GTAC for assistance.
Photo of FAQ User

FAQ User, Official Rep

  • 13,620 Points 10k badge 2x thumb

Posted 5 years ago

  • 0
  • 1

There are no replies.

This conversation is no longer open for comments or replies.