cancel
Showing results for 
Search instead for 
Did you mean: 

SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

Boopaa
New Contributor
Cant able to view or configure the SNMPv3 in my 8810-BD, getting triggers from netsight " SNMP contact lost" & cant able to configure or unconfigure the SNMP??????

Need support to fix this SNMP issue !!!!!!

Can any one help me in this.!!!!!
6 REPLIES 6

Boopaa
New Contributor
Thank you so much Huygens..!!!
Its really superb..!!!

The Issue is fixed...!!!!!!!!

Currently SNMP is functioning properly..!!!!

Ron_Huygens
Community Manager Community Manager
Community Manager
You can check the status with the command:
sh process | incl snmp

* X450a-48t.6 # sh process | incl snmp
snmpMaster 3.0.0.2 0 Stopped Wed Sep 28 06:34:26 2016
snmpSubagent 3.0.0.2 0 Ready Wed Sep 28 06:34:26 2016

Both processes should be "ready"

If one or both are "stopped" you can start them with
start process "snmpMaster"

https://gtacknowledge.extremenetworks.com/articles/Q_A/How-do-I-restart-the-snmp-process-there-is-sn...

Boopaa
New Contributor
currently its running on EXOS 15.6.4.2 patch 1-3.

When I press the TAB after tying " configure snmpv3" its showing " invalid command"

Even If i Press " Configure ? " i could not able to see "snmp" in that list.

I think the SNMP has crashed...???

AG1
Extreme Employee
Would you mind sharing the output printed by the switch after issuing each of the command lines you have mentioned above?

What version of EXOS is the switch running?

Thank you.

GTM-P2G8KFN