snmpset to clear ARP table entry on the s4 Enterasys SW

  • 0
  • 1
  • Question
  • Updated 8 months ago
  • Answered
I am trying to remotely clear one entry in a ARP table of the s4 Enterasys SW using the following command snmpset -v2c -c i 2, but it shows an error: "Error in packet." Reason: commitFailed. It works with other models such B5G124-48.
Photo of Claudio Sao Paulo

Claudio Sao Paulo

  • 70 Points

Posted 9 months ago

  • 0
  • 1
Photo of Matthew Hum

Matthew Hum

  • 362 Points 250 badge 2x thumb
in that command you failed to include a community (-c) and IP. if these were omitted intentionally then can you check the snmp section within the S4 to verify you have read/write access?