SSA temperature

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
  • (Edited)
How to enable temp-alarm S - series ?
Photo of An-Tin Liu

An-Tin Liu

  • 478 Points 250 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Vellachery, Sumeesh

Vellachery, Sumeesh, Employee

  • 3,288 Points 3k badge 2x thumb
Hi An-Tin,

To check the temperature alarm threshold, execute the command "show sys hardware".

The below-mentioned KB Article would be helpful for you:-
https://gtacknowledge.extremenetworks.com/articles/Q_A/Ambient-Temperature-monitoring-K-Series-and-S...


Regards,
Sumeesh
Photo of Bharathiraja, Suresh

Bharathiraja, Suresh, Employee

  • 3,526 Points 3k badge 2x thumb
Hi An,

Just wanted to make sure , do you want to configure temporary alarm in S-series switch directly ? or once you added this device into netsight and you want to set up alarm from netsight alarm manager?
Please confirm your requirement

Thanks,
Suresh.B
Photo of An-Tin Liu

An-Tin Liu

  • 478 Points 250 badge 2x thumb
S-series switch directly 
Photo of Mike D

Mike D, Alum

  • 3,852 Points 3k badge 2x thumb
For temp threshold (see figures below) the switch will send traps and syslog if either destination is configured.   Said another way - thresholds for temperature syslogs and traps are configured by default.  If syslog is configured, messages will be sent upon crossing this default threshold value.  If snmp is configured, traps will be forwarded upon crossing the threshold value.  

a simple syslog config example
set logging server 1 ip-addr 1.1.1.1 state enable

A simple SNMP example config: 
set snmp access groupRW security-model v2c exact read All write All notify Allset snmp access testnet security-model usm privacy exact read All write All notify All
set snmp group groupRW user public security-model v1
set snmp group groupRW user public security-model v2c
set snmp group testnet user testsnmp security-model usm
set snmp user testsnmp authentication sha :13e4bca8dcedd3de4495ee55e849e79b168e96101f41ef61db4f4ea3: privacy :0ef47a22915de70bb00b4992a194744051ca65b06da8246cb7dd4ee4:
set snmp view viewname All subtree 1
set snmp view viewname All subtree 0.0 


Figures for the trap/log event are as follows:

Ambient temperature traps/messages:  
Ambient uses chassis fan tray temperature sensors - normally the data point of interest.

HOT:    41C or more (then back to WARM at 38C)

WARM:   35C or more (then back to NORMAL at 32C)

NORMAL: 11C – 34C

COOL:   10C or less (then back to NORMAL at 13C)

COLD:   4C or less (then back to COOL at 7C)


We also support envTempHot and envTempNormal Cabletron traps/messages based on the following thresholds. This uses the board LM75 temperature sensor:

HOT:    70C or more

NORMAL: 65C or less



Hi An-Tin.

I hope this info helps.
If this isn't the information you're looking for please bump the thread again - we'll get you fixed up.
Best regards,
Mike