SSH activation

  • 0
  • 1
  • Question
  • Updated 4 years ago
Create Date: Feb 15 2012 1:48AM

Hi,

I have a question about the installation of the SSH-module.

If a want to install a new switch, I install my default firmware and reboot the switch. Perfect! Now I start the installation of the SSH-module and try to start the SSH deamon. But the "enable ssh2" command is unknown. After a reboot, it's possible. I get the same issue, if I install the firmware + ssh-module without a reboot between firmware and the SSH-module.

I think, I'm doing something wrong. But what exactly?



Thank you.



Best regards

Falk

(from Falk_Fischer)
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb
Create Date: Feb 15 2012 1:55AM

HI,
Basically if you dont want to reboot the switch after installing the SSH module, then issue the "run update" command after the SSH installation.
Also issue these commands as well.

restart process "thttpd"
restart process "snmpMaster"

Good Luck.

Regards
PJ

(from PRASAD_JACOB)
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb
Create Date: Feb 15 2012 3:01AM

Hi,

"run update" is the magic command. :-)

thanks a lot and have a nice day.



bye Falk

(from Falk_Fischer)

This conversation is no longer open for comments or replies.