Summit X440-48 creating an LACP to a Dell S600

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
Trying to create an LACP to a Dell S6000.

49                    Default             E     A     10G   FULL
50                    Default             E     A     10G   FULL

On the summit, when I look on the dell it's up 10G full duplex also.

dc-mgnt02.7 # enable sharing 2 grouping 40-50 lacp

Error: System cannot support Load Sharing among port media types with different maximum speed

I get the above EVERY single time. I've tried auto neg, forcing specific speeds and duplex. Nothing seems to work.

On the S6000 I've got it setup to use LACP I just need to configure the summit now.

Has anyone else run into this issue?
Photo of TS_MTL


  • 244 Points 100 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Stephen Williams

Stephen Williams, Employee

  • 9,076 Points 5k badge 2x thumb
Official Response
It looks like the command your using might be wrong.  To add port 49 and 50 in a share group use the command below, and make sure the Dell side has LACP enabled

# enable sharing 49 grouping 49-50 lacp

GTAC knowledge reference: