cancel
Showing results for 
Search instead for 
Did you mean: 

switch to switch: Is it important to use cross over cables?

switch to switch: Is it important to use cross over cables?

Sikander_Shah
New Contributor
i have many switches to interconnect,does it required crossover cables?
6 REPLIES 6

MANAS_BEHERA
New Contributor
Hello Sikander,

following is the command

Slot-1 16TH_FLR_SOUTH.5 # show ports 1:1 information detail
Virtual-router: VR-Default
Type: UTP
Random Early drop: Unsupported
Admin state: Enabled with auto-speed sensing auto-duplex
Link State: Ready
Link Ups: 0 Last: --
Link Downs: 0 Last: --
EDP: Disabled

EEE: Disabled
ELSM: Disabled
Ethernet OAM: Disabled
Learning: Enabled
Unicast Flooding: Enabled
Multicast Flooding: Enabled
Broadcast Flooding: Enabled
Jumbo: Disabled
Flow Control: Rx-Pause: Enabled Tx-Pause: Disabled
Priority Flow Control: Disabled
Reflective Relay: Disabled
Link up/down SNMP trap filter setting: Enabled
Egress Port Rate: No-limit
Broadcast Rate: No-limit
Multicast Rate: No-limit
Unknown Dest Mac Rate: No-limit
QoS Profile: None configured
Ingress Rate Shaping : Unsupported
Ingress IPTOS Examination: Disabled
Ingress 802.1p Examination: Enabled
Ingress 802.1p Inner Exam: Disabled
Egress IPTOS Replacement: Disabled
Egress 802.1p Replacement: Disabled
NetLogin: Disabled
NetLogin port mode: Port based VLANs
Smart redundancy: Enabled
Software redundant port: Disabled
IPFIX: Disabled Metering: Ingress, All Packets, All Traffic
IPv4 Flow Key Mask: SIP: 255.255.255.255 DIP: 255.255.255.255
IPv6 Flow Key Mask: SIP: ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
DIP: ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff

auto-polarity: Enabled
Shared packet buffer: default
VMAN CEP egress filtering: Disabled
Isolation: Off
PTP Configured: Disabled
Time-Stamping Mode: None
Synchronous Ethernet: Disabled
Dynamic VLAN Uplink: Disabled
VM Tracking Dynamic VLANs: Disabled

Regards,
Manas Ranjan

Farookh_shaikh
New Contributor
try this command show port information detail

Senguttuvan__Ar
Extreme Employee
show ports information detail will show if polarity is enabled or not for the port

Sikander_Shah
New Contributor
how to check that auto polarity is off or on?
GTM-P2G8KFN