tunel entre CWE y AP3610 remoto a través de internet , es posible?

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
Hola, tengo un proyecto donde se propone tener una CWE en un sitio fijo y tener el control de alrededor de 10 AP en oficinas remotas sin la utilización de hardware VPN, el enlace entre CWE y AP es a través de Internet, es posible esta configuración sin la utilización de VPN?.
Photo of Martin Perez

Martin Perez

  • 212 Points 100 badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Jeremy

Jeremy, Embassador

  • 9,788 Points 5k badge 2x thumb
El reenvío de puertos y el establecimiento de un defecto en la configuración estáticaHWC.
Photo of Martin Perez

Martin Perez

  • 212 Points 100 badge 2x thumb
Tan yo u, necesito algo de información, alguna alternativa o manual para este tipo de instalación?
Photo of Doug Hyde

Doug Hyde, Technical Support Manager

  • 20,192 Points 20k badge 2x thumb
Photo of Martin Perez

Martin Perez

  • 212 Points 100 badge 2x thumb
T ank you, I need more información about it, can you help me?, or alternative about it, I can read in Thor Link that I should configurate public IP in the controller , where can I get more information about is or configuration guide.
Photo of Jeremy

Jeremy, Embassador

  • 9,788 Points 5k badge 2x thumb
If the guide doesn't make sense, maybe contact Extreme for professional services or pay a contractor to help out.  Setting up an entire wireless controller would be tricky communicating through the hub.
Photo of Jeremy

Jeremy, Embassador

  • 9,788 Points 5k badge 2x thumb
But... You are going to have to configure your L2 interfaces.  Setup an interface with a public IP and allow the appropriate ports to be open.  Use the static config  option in the AP config to point the AP to the public IP address of the controller.  Assuming everything is setup right, the AP will establish it's secure tunnel.   It's quite easy to do, however, I am not 100% sure it is the recommended way.  Currently, I tunnel everything through an ASA IPSEC tunnel for remote APs.
Photo of Martin Perez

Martin Perez

  • 212 Points 100 badge 2x thumb
hello, thank you , I tray mount a laboratory  , but this is my problem now.
https://community.extremenetworks.com/extreme/topics/ap-remote-office-offline-in-the-cwe-no-tunel?rf...
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 45,044 Points 20k badge 2x thumb
Take a look into this post....
https://community.extremenetworks.com/extreme/topics/bridged-ap-connected-client-cannot-obtain-dhcp-...

If that doesn't make sense I'd recommend what Jermey suggested ...
" contact Extreme for professional services or pay a contractor to help out"
Photo of Drew C.

Drew C., Community Manager

  • 37,324 Points 20k badge 2x thumb