Unable to save the configuration in Extreme X250e-48p stack switch.

  • 0
  • 1
  • Question
  • Updated 4 years ago

Unable to save the configuration in Extreme X250e-48p stack switch. Its giving the below error while saving.

(Stack.7 # save

The configuration file primary.cfg already exists.

Do you want to save configuration to primary.cfg and overwrite it? (y/N) Yes

Saving configuration on master .............................. done!

Synchronizing configuration to backup ........... done!

error while tarring/zipping config, config could not be saved on Standbys!)

Photo of Sowjanya

Sowjanya

  • 110 Points 100 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of Tomasz Lubas

Tomasz Lubas

  • 534 Points 500 badge 2x thumb
As far as i know the config  is held by the master switch in the stack :)
Photo of Paul Russo

Paul Russo, Alum

  • 9,694 Points 5k badge 2x thumb
Hello Sowjanya  I have not seen this error before.  Can you please open a case with GTAC?

How many switches are in the stack?

Thanks
P
Photo of Sowjanya

Sowjanya

  • 110 Points 100 badge 2x thumb

Hi Paul,

There are 3 switches in the stack..

Image running in the device is ExtremeXOS version 12.5.1.6


Photo of Grosjean, Stephane

Grosjean, Stephane, Employee

  • 12,562 Points 10k badge 2x thumb
Config is also copied to the backup in a stack. As Paul suggested, please open a case with GTAC, that can be a corrupted CF, or something...
Photo of Paul Russo

Paul Russo, Alum

  • 9,694 Points 5k badge 2x thumb
thanks Sowjanya  GTAC will need to look at the Show Tech to see what might be going on.  As Stephane said this could range from a corrupt config to low memory to something else.

GTAC is really the best approach to getting it resolved.

Thanks
P