Vlan Graphing

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
Hi All,

We have just replaced a few Cisco Switches with Extreme Switches, with the Cisco switches we could graph each vlan on the switch. I just would like to understand if this is possible with Extreme, we have configure ports x:xx monitor vlan yyyy, so the data is there. Just need the correct MIB id.

Thanks
Ian 
Photo of Ian Worms

Ian Worms

  • 422 Points 250 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Stephen Williams

Stephen Williams, Employee

  • 9,050 Points 5k badge 2x thumb
Ian,

What do you mean by graphing each vlan on the switch?  Are you looking for a MIB that shows you the vlans on the switch?  Help me understand, I'm sure we can help out.
Photo of Ian Worms

Ian Worms

  • 422 Points 250 badge 2x thumb
Hi

I would like to graph the amount traffic for each vlan on the switch, does this help.

Best Regards
Ian
Photo of Stephen Williams

Stephen Williams, Employee

  • 9,050 Points 5k badge 2x thumb
Yep.  You need to enable VLAN monitoring on the VLANs you want to graph.

configure ports all monitor vlan <vlan_name>

Then you can see the VLAN stats with the below commands.

show vlan statistics no-refresh 

Depending on the VLAN tags and everything the OID's will be different per vlan.  With the below OUIs you can just do a SNMP "get next" to find the correct vlans.  The numbers will match the command "show vlan statistics no-refresh"

Name extremePortVlanTotalReceivedFramesCounter
OID .1.3.6.1.4.1.1916.1.2.8.2.1.8

Name extremePortVlanTotalTransmittedFramesCounter

OID .1.3.6.1.4.1.1916.1.2.8.2.1.13
Photo of Stephen Williams

Stephen Williams, Employee

  • 9,050 Points 5k badge 2x thumb
You can get the VLAN indexes with a "get bulk" on this OID.  .1.3.6.1.4.1.1916.1.2.8.2.1.2  but make sure you're on EXOS 15.6.2.12-patch1-2, 15.7.2 or 16.1 and higher per this KCS article.

https://gtacknowledge.extremenetworks.com/articles/Solution/Problem-with-downloading-vlan-counters-f...
(Edited)
Photo of Ian Worms

Ian Worms

  • 422 Points 250 badge 2x thumb
Hi Stephan,

Thanks for the reply, we will upgrade the XOS and provide feedback.

Ian
Photo of Edwin Candelario

Edwin Candelario

  • 80 Points 75 badge 2x thumb
Hi !
I am using s3 chassis with   is posible to graph utilization in a interface vlan ?

B O N D E D   S 3 - A   C H A S S I S
Command Line Interface

Extreme Networks, Inc.
145 Rio Robles
San Jose, CA 95134
Phone:  +1 408 579-2800
E-mail: support@extremenetworks.com
WWW:    http://www.extremenetworks.com

(c) Copyright Extreme Networks, Inc. 2015

Chassis Serial Number:      xxxxxxxxx
Chassis Firmware Revision:  08.32.02.0008
Photo of Brandon Clay

Brandon Clay, Escalation Support Engineer

  • 13,486 Points 10k badge 2x thumb
Hi Edwin,

I've split this out into its own thread for better visibility.

-Brandon

Please reference the new conversation here: VLAN Utilization Graphing via SNMP

This conversation is no longer open for comments or replies.