Vlan tagged policy mappings on C3

  • 0
  • 1
  • Question
  • Updated 4 years ago
  • Answered
Hello all!   I am trying to set  vlan mapping to policy on a trunk port of a C3.   I did check port level mappings enable under the policy manager edit pulldown.  I see no reference to this action in the config of the switch after I enforce.  Is this possible with a C3 or did I miss a step or two?
thnks in advance
walt
Photo of Walt Witkowski

Walt Witkowski

  • 436 Points 250 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of James A

James A, Embassador

  • 7,002 Points 5k badge 2x thumb
The Feature Support B3/C3/G3 section in the NetSight Policy Manager Firmware Support help section says Tagged Packet VLAN to Role Mapping is supported, but
On B3 and C3, this feature will not work properly unless the "Number of Users Allowed" attribute on a port is set to 2 or more. Supported on both device and port level, but only one mapping is allowed at the device level and on each port.
So maybe you need to set it at the device level too?