VOSS "Default" command

  • 0
  • 1
  • Question
  • Updated 4 weeks ago
  • Answered
What about the "default" command in VOSS ?


I see this command at interfaces, MLT, etc. and at global command level.

Here an example (VSP7200 - V7.0.0):
SW11:1(config-mlt)#?  
default     Default settings
  ... 
SW11:1(config-mlt)#default ? 
Default settings
  flex-uni       Set flex-uni to default on mlt interface
  ip
  isis           set interface level isis parameters to default value
lacp Set lacp for specific mlt to default
smlt           Create default smlt on a specific mlt
svlan-porttype Set svlan port type to default
virtual-ist    Create virtual-ist on MLT with default value
SW11:1(config-mlt)# 

Unfortunately i do not find any manual where this command or the usage will be explained. CLI Reference does not explain this command.

Do anyone tell me which VOSS manual explain the usage ?? Or have anyone an example how to use this command ?


Regards
Photo of M.Nees

M.Nees, Embassador

  • 9,958 Points 5k badge 2x thumb

Posted 4 months ago

  • 0
  • 1
Photo of Ludovico Stevens

Ludovico Stevens, Employee

  • 430 Points 250 badge 2x thumb
It restores a setting to its default value (i.e value it would have under switch factory defaults)
Photo of M.Nees

M.Nees, Embassador

  • 9,958 Points 5k badge 2x thumb
Does the value restore to "factory" default or can i define a custom default value ?
Do you know which manuel does explain that ?
Photo of Ludovico Stevens

Ludovico Stevens, Employee

  • 430 Points 250 badge 2x thumb
Restores value to factory default. No, you cannot define a custom default value."default" and "no" are standard command modifiers which can precede CLI configuration commands, to default or negate a config setting.This is supposed to be Cisco-like.I guess it should be in the Using CLI guide, but seems not to be there...
Photo of Roger Lapuh

Roger Lapuh, Employee

  • 470 Points 250 badge 2x thumb
here is where the default operator is explained:   starting on page 17. I hope this helps.



Photo of Hyung Jin Kim

Hyung Jin Kim, Employee

  • 258 Points 250 badge 2x thumb
default command operator

You can reset the modified configuration of a command to the default configuration by using the

default operator. For more information about the default value for each command, see CLI

Commands Reference.

Use the ? command completion along with the default keyword in each configuration mode, to view

the list of commands that support the default operator. For more information, see Command

completion on page 15.

Example

Configure csnp-interval to its default value. The default value of csnp-interval is 10

seconds.