cancel
Showing results for 
Search instead for 
Did you mean: 

WDS Bridge Point-to-point Link

WDS Bridge Point-to-point Link

Valter_Veiga
New Contributor III
What the behavior of a WDS Bridge link between two sites in an controller loss scanerio?

Will it maintain the WDS Link ?

Exemple: Using two Access-point 3865, with two options enable: ( Maintain client sessions in event of poll failure, Restart service in the absence of controller)

6 REPLIES 6

Gareth_Mitchell
Extreme Employee
Valter

Does the WDS link stay up for a few minutes before it goes down?

If so I believe in this case the preferred option is to use MESH, not WDS.

If you really have to use WDS for some reason, for example, an existing deployment, it maybe easier to create a site and add parent and child to this site.

Let me know if this helps.

-Gareth

Valter_Veiga
New Contributor III
Hi,

The Setup is that. Site 1 : Controller - LAN - F.O - Site 2: - LAN - AP Parente ....wds.... SIte 3: AP Child - Lan - PC.

Tomorrow we will investigate

Ronald_Dvorak
Honored Contributor
I'm running a V2110 with the same version and I've just enabled my WDS and it works if the link to the controller is down ( AP3801i in my case).

My setup....

Controller - LAN - AP-parent ......... WDS.......... AP-child/WDS bridge - LAN - PC

Is it the same for you = connect LANs in different buildings via WDS or is the client in building#2 connected via WLAN to the WDS-child.
If that is the case what privacy/authentication is used on the WLAN service.

Valter_Veiga
New Contributor III
GTM-P2G8KFN