What do I need to have to stack X460-48P switches

  • 0
  • 1
  • Question
  • Updated 1 year ago
  • Answered
Photo of BILL REITLER

BILL REITLER

  • 100 Points 100 badge 2x thumb

Posted 1 year ago

  • 0
  • 1
Photo of Jefferson Lemos

Jefferson Lemos

  • 338 Points 250 badge 2x thumb
Hi Bill, below have a link where you can find the all informations about stacking on Exos:

https://gtacknowledge.extremenetworks.com/articles/Q_A/Where-Can-I-Find-the-EXOS-Stacking-Tool

Att
(Edited)
Photo of Andrew Imam

Andrew Imam, Alum

  • 1,026 Points 1k badge 2x thumb
Hi Bill,

In addition to the Stacking Tool that Jefferson mentioned, please use the steps outlined in the following GTAC Knowledge base article to configure and enable stacking on your X460-48p switches:

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-create-stack-with-Summit-X460-48p-a...


Please let us know if you have any questions.
Thank you.

Best regards,
Andrew
Photo of Jefferson Lemos

Jefferson Lemos

  • 338 Points 250 badge 2x thumb
Andrew, Thanks for your support !!! 
Photo of Larry Kunz

Larry Kunz, Employee

  • 1,450 Points 1k badge 2x thumb
The stacking tool, which Jefferson referenced, is very helpful.  In addition, here's a link to a page from the Hardware Installation Guide with specific stacking considerations for X460 switches.

Larry Kunz
Information Development
Extreme Networks
Photo of BILL REITLER

BILL REITLER

  • 100 Points 100 badge 2x thumb
Thanks guys that was the info I needed. Guess I am ordering some hardware.