cancel
Showing results for 
Search instead for 
Did you mean: 

What value do I need for Auto Tx Power Ctrl Adjust on AP 3605?

What value do I need for Auto Tx Power Ctrl Adjust on AP 3605?

Thomas_Randolph
New Contributor
Getting ready to enable Auto Tx Power Ctrl (ATPC) for AP3605. What value do I need for Auto Tx Power Ctrl Adjust? Is this the range up or down it can go or does the min max values set that? Also how does it determine when it needs to adjust power? Any info is appreciated.
6 REPLIES 6

Thomas_Randolph
New Contributor
Ok. Thanks

Doug
Extreme Employee
Typically it would a name chosen based on location.
Example: Building X, Building Y

Doug Hyde
Director, Technical Support / Extreme Networks

Thomas_Randolph
New Contributor
Is it ok for all APs to be defined with the same RF domain?

Doug
Extreme Employee
Hello Thomas,

A typical setting would be to set the Max to the highest setting in the config and Min to the lowest setting (in dBm). The system will automatically try and adjust in that range. It does so by sending packets in the air with a name defined in the RF Domain field. Each access point hears that packet and can determine how to automatically adjust the transmit power of an ap.
Doug Hyde
Director, Technical Support / Extreme Networks
GTM-P2G8KFN