cancel
Showing results for 
Search instead for 
Did you mean: 

Why do i not have all UNII2e channels

Why do i not have all UNII2e channels

Simon_Vosper
New Contributor III
Hello

We have country code set for UK. Can someone please tell me why I don't get the full set of UNII2e channels to choose from. I only get 100, 104, 108 and 112. What has happened to the remaining 7 channels that should be available.
15 REPLIES 15

Simon_Vosper
New Contributor III
Dennis, that's great, thank you for providing this information Doug - thanks for getting an answer on this, I appreciate the effort. Regards Simon

Doug
Extreme Employee
Thanks Dennis.
Doug Hyde
Director, Technical Support / Extreme Networks

drysell
Extreme Employee
Simon / Doug,

We confirmed with the compliance team, and this is a special case for the AP3715i. There were some limitations observed during certification testing. So for these reasons when AN-HT40 is selected only the channels in the pull down shown below would be available. Channels 132/136 are permanently disabled for band edge issues and channels 116-120 and 124-128 are disabled for DFS Channel availability check reasons. Channel 140 is not allowed as it would only be bonded up to channel 144 which is not allowed. As a result, for the AP3715i you are limited to the existing channels shown in the pull down. Regards,

Dennis

Ian_Broadway
New Contributor III
Hello, Sorry to bring this up again, can we elaborate on "channels 116-120 and 124-128 are disabled for DFS Channel availability check reasons." I assume this is a vendor specific (Extreme) restriction of some sort? I can quite happily use the channels on a different vendor in the UK.
GTM-P2G8KFN