Wireless - SSID grey'ed out ?

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
Hi, 


I have an issue where under the access points, if I want to add an SSID to be broadcasted from an AP - it is grey'ed out.


Previously, it would be clickable, but after a page refresh, it would revert back to being unclicked.  So we upgraded the V2110 (v.9.15) and migrated it to Hyper-V.  

Now the option to enable an SSID on an AP is grey'ed out ?  any reasons for this ?  


*the SSID and AP are not part of a SITE, nor are the default configuration templates imposed.

thanks !
Photo of Dewald Botha

Dewald Botha

  • 674 Points 500 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Gareth Mitchell

Gareth Mitchell, Extreme Escalation Support Engineer

  • 5,476 Points 5k badge 2x thumb
Hi

Is the AP in a load group?
Are all the components (vns, wireless service etc) enabled?

-Gareth
Photo of Dewald Botha

Dewald Botha

  • 674 Points 500 badge 2x thumb
Hi Gareth, 

Yes they are - based on their physical locations.  
Yes again - these are APs that are deployed over a large site, where only some of them do not want to enable a certain SSID over radio 2 for example, or for that matter, disable it.

Just curious as to the reason behind this, could it be the fact that the load-group overrides it ?  But then, why can't I enable/disable the SSID on the AP - or am I missing something ?

thanks.
Photo of Gareth Mitchell

Gareth Mitchell, Extreme Escalation Support Engineer

  • 5,476 Points 5k badge 2x thumb
Hi Dewald

Yes the load group over-rides selection of wlan service via the AP wlan assignement tab of the GUI.

See: https://gtacknowledge.extremenetworks.com/articles/Solution/Trying-to-remove-a-WLAN-service-from-a-radio-but-the-check-box-is-grayed-out

-Gareth
Photo of Dewald Botha

Dewald Botha

  • 674 Points 500 badge 2x thumb
Thanks Gareth !