WS-AP3705i Console Port

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered

We want to use AP3705i console port.
Can we configuration from console port of AP3705i? (IP, gateway, etc.)
to tell us ;
AP console port pin assignment , terminal setting

Regards,

Photo of kouichi ohtomo

kouichi ohtomo

  • 260 Points 250 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 44,984 Points 20k badge 2x thumb
Hi, you'd set the following parameter via the console port to allow the AP to connect to the controller if you don't use an DHCP server...
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave

The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.
Photo of kouichi ohtomo

kouichi ohtomo

  • 260 Points 250 badge 2x thumb

Thank you for reply.

We were able to confirm that it can be set from the console port.


However, there was the discovery of 2 points.

1, console cable, in the Cisco console, was not a Enterasys console.
2,  It was required first to [cset dhcpc disable] command

** We have tested with firmware version "08.32.08.0002".

Regards,

Photo of juan romero

juan romero

  • 400 Points 250 badge 2x thumb
Is there a way to confirm configuraration a "show configuration" command or something like that?
Photo of James A

James A, Embassador

  • 6,510 Points 5k badge 2x thumb
There's "cget config" which is fairly comprehensible.
Photo of juan romero

juan romero

  • 400 Points 250 badge 2x thumb

Thank you very much, I'll try the command.