x440 G2 route sharing

  • 0
  • 1
  • Question
  • Updated 7 months ago
  • Answered
Hi I am looking at ECMP on a x440 G2 switch.
The x440 is connected to two seperate routers and I would like to load balance traffic across them.
The manuals indicate that it is supported on the x440 G2 but you can not configure the hashing.

The x440 is running firmware 22.3.1.4-patch1-4.

The "enable iproute sharing" command is not available.
Is this enabled by default? or do I need to enable this?

Thx
Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,214 Points 5k badge 2x thumb

Posted 7 months ago

  • 0
  • 1
Photo of Parthiban V

Parthiban V, Employee

  • 618 Points 500 badge 2x thumb
Hi,
IP Route sharing is not supported in x440 G2.

Thanks,
Parthiban.V
Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,214 Points 5k badge 2x thumb
Hi Parthiban

Thank you for the feedback but in the exos user guide it states that the ecmp hashing algarithm can not be changed on the x440g2's. Indicating that it is supported but limited. Also looking at some older gtac notes it also states that the older x440 also supported this. https://gtacknowledge.extremenetworks...

With oldercode (21.x) i could also set the maximum amount of gateways for the sharing.

Can we confirm this 100%?
Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,214 Points 5k badge 2x thumb
Below is the link from exos userguide 22.

https://documentation.extremenetworks...