XOS broadcast suppression syntax

  • 0
  • 1
  • Question
  • Updated 4 years ago
  • Answered
Can anyone tell me the syntax to enable broadcast suppression on XOS x460 switch
Photo of shakil khan

shakil khan

  • 280 Points 250 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of PARTHIBAN CHINNAYA

PARTHIBAN CHINNAYA, Alum

  • 4,362 Points 4k badge 2x thumb
configure ports rate-limit flood

then u should be able to say "broadcast 1000"
Photo of shakil khan

shakil khan

  • 280 Points 250 badge 2x thumb
when i type the above command i dont get the option flood
#configure port 2 rate-limit ?

egress

option i get is (eggress and not flood
Photo of PARTHIBAN CHINNAYA

PARTHIBAN CHINNAYA, Alum

  • 4,362 Points 4k badge 2x thumb
whats the exos version ?
Photo of PARTHIBAN CHINNAYA

PARTHIBAN CHINNAYA, Alum

  • 4,362 Points 4k badge 2x thumb
Usage GuidelinesUse this command to limit the amount of ingress flooding traffic and to minimize the network impact of
broadcast loops.
To display results, use the show ports rate-limit flood command.
Example
The following command rate limits broadcast packets on port 3 on a stand-alone switch to 500 pps:


configure ports 3 rate-limit flood broadcast 500----------------------this is documented in command ref


History
This command was available in ExtremeXOS 11.1.
Platform Availability
This command is available on the BlackDiamond X8, BlackDiamond 8800 series switches, SummitStack,
and the Summit family of switches.
Photo of shakil khan

shakil khan

  • 280 Points 250 badge 2x thumb
what i am trying to do is to convert the following config from a HP box to XOS extreme but i am not sure of the syntax as you have given me the help please check below if this is correct?

interface Ethernet1/0/2

 stp edged-port enable  >>>>(1)

 broadcast-suppression pps 3000>>>(2)

 undo jumboframe enable>>(3)

 MAC-authentication>>(4) not sure on this one please advice the syntax

------------------------------------------

FOR (1)

#create stpd s0

#configure stpd s0 mode dot1w

#configure stpd s0 default-encapsulaion dotd

#configure stpd s0 add vlan data ports all

#configure stpd s0 ports link-type edge 2 edge-safeguard enable

#enable stpd s0

--------------------------------

FOR (2)

#configure ports 1-47 rate-limit flood broadcast 3000 pps

-----------------------------------

FOR (3)

#disable jumbo-frames ports all

------------------------------

FOR (4)

help needed here ?

Photo of PARTHIBAN CHINNAYA

PARTHIBAN CHINNAYA, Alum

  • 4,362 Points 4k badge 2x thumb
I would recommend you to contact TAC.
incase if you face any issues during implementation they can quickly help you out.