I am sory but I do not understand the request... The NAC does not have anything connected to the AP serial number. If you want copy the config from one AP to another, you can use following procedure: Backup your controller config Extract the backup In the config (cli) file find your AP config Ssh to the controller and configure the new AP with commands you take from the backup. If it is not your goal, please redefine your question.
Scenario: AP1 is bad and I want to add a new AP to replace. Is it possible through NAC CLI to change just the serial number of AP1 to the new AP and have that AP use the config based on being assigned a new serial number. (i.e. AP1 s/n 1420xxxxxxx replaced with new AP 1357xxxxx via cli ap command within NAC manager or Netsight GUI)
Already have an account? Login
No account yet? Create an account
Enter your username or e-mail address to receive an e-mail with instructions to reset your password.
Sorry, we're still checking this file's contents to make sure it's safe to download. Please try again in a few minutes.
Sorry, our virus scanner detected that this file isn't safe to download.
We use 3 different kinds of cookies. You can choose which cookies you want to accept. We need basic cookies to make this site work, therefore these are the minimum you can select. Learn more about our cookies.