Header Only - DO NOT REMOVE - Extreme Networks

How To Manage SNMP credentials (Communities) and passwords in Enterasys NetSight


Userlevel 3
Enterasys GTAC veteran Bob Maheu describes How To use NetSight to manage SNMP credentials (also known as community strings or passwords) on devices managed within Enterasys NetSight Management System

5 replies

Userlevel 1
We would like change the snmp credential in all our devices (250 devices), How can we do this with Enterasys Netsight? Thanks a lot.
Userlevel 7
Hello, This video can walk you through the process... http://www.youtube.com/v/6SgPyMp98-c&rel=0&autoplay=1 You can set this change on multiple devices. It is very dangerous if you push out a misconfiguration. I would suggest you try this on one device first to make sure you set the snmp passwords properly. You can then push the changes to all 250 devices. If you have any further questions please feel free to contact the GTAC for assistance. Regards, Doug Hyde Sr Support Engineer Enterasys Networks
Userlevel 1
Thanks Doug. we'll try it carefully. Regards
Userlevel 1
Now we have another question with this point, How can change the login credential (cli- admin/password) in all our devices? Is this possible with Netsight too? Thanks a lot.
Userlevel 2
Rey Juan Carlos University [communications wrote:

]Now we have another question with this point, How can change the login credential (cli- admin/password) in all our devices? Is this possible with Netsight too? Thanks a lot.

This is an additional question to the original post that everyone could benefit from. Please reference the new topic here: Is is possible to change login credentials for all SNMP devices with Netsight?

Reply