Header Only - DO NOT REMOVE - Extreme Networks

learned mac address refer to group


I have created a DEVICE GROUP with ITS INTERNAL only two port/pc so I STARTED the flexview "learned mac addresses" to know if the 2 pc are turned on but my view show nothing.

8 replies

Userlevel 7
Did you click on the green play button icon in the upper right corner of this screen to start the query ?!
Yes absolutely!
Userlevel 7
Does it work if you run it on the whole switch isntead of an port group ?

YES ! but I need to show only the computers in that group
otherwise what is the purpose of creating groups?
Userlevel 7
Visconti wrote:

YES ! but I need to show only the computers in that group
otherwise what is the purpose of creating groups?

Calm down... I only wanted to make sure that it works in general before adding a device group.
Visconti wrote:

YES ! but I need to show only the computers in that group
otherwise what is the purpose of creating groups?

Sorry 🙂 I am calm with you ..... I am less calm with Netsight !!
Userlevel 7
Visconti wrote:

YES ! but I need to show only the computers in that group
otherwise what is the purpose of creating groups?

I get the same result..... I'd open a GTAC ticket as I'm not sure whether that will work with this flexview.
Visconti wrote:

YES ! but I need to show only the computers in that group
otherwise what is the purpose of creating groups?

I'm afraid so 😞

Reply