Header Only - DO NOT REMOVE - Extreme Networks

Port Default Policy Role between Console and Policy Mngr is out-of-sync

  • 28 April 2014
  • 2 replies
  • 304 views

Why would Console and Policy Mngr differ when viewing the default port policy role that is being applied. Policy Mngr is showing in one case 20 ports with a specific role and Console only shows the role on 10 of those ports

2 replies

Userlevel 7
are all those ports the same king (physical). In PM there is option to show also virtual ports = LAG.

It should read the same OID from the mib, the data should be the same. Can you share the screenshot?

Z.
are all those ports the same king (physical). In PM there is option to show also virtual ports = LAG.

It should read the same OID from the mib, the data should be the same. Can you share the screenshot?

Z.
Enterasys has confirmed that they are aware of this issue. I am running Netsight 5.1 and Netsight ver.6.1 is in the works with a fix. Screen shots are available in the case 01021283. Clarification... When viewing Netsight Console the "BasicPolicy" tab all the ports set to have a specific default role do not show the role, under the "Default Role" column. If I SSH to the switch (C3) and do a "show config policy" the "set policy port xx.x x is there for every port intended. The Netsight Policy Mngr. also shows all the intended ports for the role when I select a role and under the "ports" tab do a retrieve operation.

Reply