Header Only - DO NOT REMOVE - Extreme Networks

Port utilization in % on uplinks using Netsight


I want to monitor the utilization in % on the uplinks of XOS switches. How do I do this?
In the console you can select the flexview "port utilization in percent", which is the one I need. But how do I add the ports I want to see and how do I display them in OneView?

4 replies

Userlevel 4
Hi,Have you tried custom reports, under reports?

Select a switch, collect interface statistics


Alternatively you can collect interface stats from console [May have to depending of version of Netsight running 6.1 vs 6.2 vs 6.3]


After 10-15 minutes, we will have collected interface stats to start graphing.

In Oneview
Under Custom Reports Select interfaces and choose what you want to graph %utils



Not sure if this was added in 6.2 or 6.3
Save it report designer as an option


In Administration tab go to Report Designer



Pick the custom report option we created, additional elements can be created and added together as well for a single report.



Save then under reports we can then view anything we created

Great! This is exactly what I was looking for! I will check it out later but I guess this is the solution.
Userlevel 6
Ramon Voorn wrote:

Great! This is exactly what I was looking for! I will check it out later but I guess this is the solution.

Welcome to the Hub Ramon. That's how this community rolls!

You'll find lots of knowledge sharing, purple passion and speedy responses.

Appreciate you joining us.
Userlevel 4
Ramon Voorn wrote:

Great! This is exactly what I was looking for! I will check it out later but I guess this is the solution.

Definitely let us know if you have any issues

Reply