Header Only - DO NOT REMOVE - Extreme Networks

DHCP option 132


How configure a DHCP Server on A4-Series for a specific vlan?

7 replies

Userlevel 7
I'm note sure whether I unterstand so please explain in more detail.... is the A4 the DHCP server in this VLAN or should it be the relay or ....!?
Userlevel 4
If you are setting up a dhcp server on the securestack give this article a read.
How to configure DHCP server on Securestack
Daniel Coughlin wrote:

If you are setting up a dhcp server on the securestack give this article a read.
How to configure DHCP server on Securestack

I tried this article, but i could not.

I did not understand these parts below.
set dhcp pool host-pool1 client-identifier 01:00:80:C7:13:3A:DB set dhcp pool host-pool1 host 10.10.10.25 255.255.255.0 set dhcp pool host-pool2 client-identifier 01:00:18:8B:C9:16:5F set dhcp pool host-pool2 host 10.10.10.26 255.255.255.0[/code]set dhcp pool shoretel option 156 ascii ftpservers=192.168.1.101,layer2tagging=1,vlanid=110 [/code]
Userlevel 7
Daniel Coughlin wrote:

If you are setting up a dhcp server on the securestack give this article a read.
How to configure DHCP server on Securestack

You'd look up the explanation in the CLI refernce guide...
https://documentation.extremenetworks.com/Active_Archive/B-Series/B-5/SW_Doc/9034706-01_B5_CLIRef_FW...

1) Use this command to configure an IP address and network mask for a manual DHCP binding = so they always get the same IP
#set dhcp pool host-pool1 client-identifier 01:00:80:C7:13:3A:DB
#set dhcp pool host-pool1 host 10.10.10.25 255.255.255.0
set dhcp pool host-pool2 client-identifier 01:00:18:8B:C9:16:5F
set dhcp pool host-pool2 host 10.10.10.26 255.255.255.0


2) Just a DHCP scope with special options for shoretel phones = in that case the phone get's the ftp (to get the config file) and a VLAN ID - but that is for that phone model and not all vendors use the same format and options.
#set dhcp pool shoretel option 156 ascii ftpservers=192.168.1.101,layer2tagging=1,vlanid=110
Userlevel 7
Daniel Coughlin wrote:

If you are setting up a dhcp server on the securestack give this article a read.
How to configure DHCP server on Securestack

Here the one for the A4...
https://documentation.extremenetworks.com/Active_Archive/A-Series/A-4/SW_Doc/9034705-01_A4_CLIRef_FW...
Daniel Coughlin wrote:

If you are setting up a dhcp server on the securestack give this article a read.
How to configure DHCP server on Securestack

Ok, I understood the example above.
I want to create two VLANs on the switch and one DHCP server. Where the DHCP server will distribute ips over VLAN 2. I don't know how to use option 132 in DHCP on this switch. Thanks.

Reply