Header Only - DO NOT REMOVE - Extreme Networks

snmpset to clear ARP table entry on the s4 Enterasys SW

I am trying to remotely clear one entry in a ARP table of the s4 Enterasys SW using the following command snmpset -v2c -c i 2, but it shows an error: "Error in packet." Reason: commitFailed. It works with other models such B5G124-48.

1 reply

Userlevel 1
in that command you failed to include a community (-c) and IP. if these were omitted intentionally then can you check the snmp section within the S4 to verify you have read/write access?