Question

BD8800 Hitless Upgrade Questions


Userlevel 2
Hi,

I have done a half of hitless upgrade procedure of BD8800 with following "show switch" output after that.
Slot: MSM-A MSM-B *
------------------------ ------------------------
Current State: BACKUP MASTER
Image Selected: primary secondary
Image Booted: primary secondary
Primary ver: 15.7.1.4 12.5.4.5
Secondary ver: 15.7.1.4 15.6.1.4
Config Selected: primary.cfg
Config Booted: primary.cfg[/code]Why there is no selected and booted config on MSM-A (backup, just upgraded)? Is it safe to do "run msm-failover" command on this situation?

Best regards,

3 replies

Userlevel 2
Any idea?
Userlevel 7
Hi Lazuardi,
I think at this point, it would be best if you can contact our GTAC team.
Userlevel 2
Hi Drew,

Of course, I have contacted GTAC and waiting for the solution. I post on this forum to see if somebody has same issue. Maybe there is some step by step with CLI output about successful BD8800 hitless upgrading procedure.

Best regards,

Reply