Question

Cannot get node in stack to pass data

  • 17 July 2019
  • 1 reply
  • 181 views

We have a stack of three switches of the Summit X450-G2.

One failed and was replaced with the same one. Went through the usual process of replacing using enable stacking and assigning a number.

We have it listed as a standby along with slot 3. 1 being the master. However, slot 1 and 3 have internet access while slot 2 does not and is not receiving anything from the DHCP. Everything shows up fine with show stacking and stacking detail.


Slot 1 versions:
Primary 16.1.0.1.8
Secondary 21.1.1.4

Slot 2:
Primary: 22.6.1.4
Secondary: 21.1.1.4

Slot 3:
Primary: 16.1.0.1.8
Secondary: 21.1.1.4

Again, slot 1 and 3 have internet connection. Slot 2 can see the computers along with the other nodes, but will not provide an IP or internet connectivity.

1 reply

Userlevel 2
What if you do a synchronize slot 2 which will not only synchronize the slot but reboot as part of the process (slot 2) it to see if that clears things up?

Reply