i am playing around with "conf_diff.py" and i have some problems to understand the output.
Switch X450G2-48p-G4 - EXOS: 22.214.171.124
SW-TEST.21 # run script conf_diff.py
Comparing configurations, please wait...
disable mac-lockdown-timeout ports 49
configure mac-lockdown-timeout ports 49 aging-time 15
configure ports 49 far-end-fault-indication off
disable vman cep egress filtering ports 49
configure port 49 dot1p 0
disable snmp traps port-up-down port 50
enable diffserv examination port 50
configure port 50 reflective-relay off
configure port 50 isolation off
disable flow-control tx-pause port 50
disable flow-control rx-pause port 50
configure ports 50 forward-error-correction off
disable mac-lockdown-timeout ports 50
configure mac-lockdown-timeout ports 50 aging-time 15
configure ports 50 far-end-fault-indication off
disable vman cep egress filtering ports 50
configure port 50 dot1p 0
If line starts with '+', the command has been added since last save.
If line starts with '-', the command was present in the last save, and has been deleted.
- configure ports 27 display-string Auth-TEST-MN
+ configure ports 27 display-string Auth-TEST-MN2
Note that this script has cleared the CLI dirty bit. The configuration has not been saved.
SW-TEST.22 #[/code][/code]What does mean the block of commands between "please wait ..." and "if line starts ...".
At GitHub example there is no output seen.
Is there a special meaning or is this maybe a result of EXOS 22.4 and some upcoming incompatibility with python script (because it seem to be programmed for an older EXOS version)