Header Only - DO NOT REMOVE - Extreme Networks

Convert Cisco CLI to Extreme EXOS CLI


Hi all,
May I ask does Extremenetworks provide convert tool to translate cisco CLI to Extreme CLI? Is someone could help me to translate it if no tools could help? Thanks in advance.

access-list 103 permit ip any host 172.30.106.71
access-list 103 permit ip any host 172.30.106.72

class-map highservice
match access-group 103

policy-map highpolicy
class highservice
bandwidth 4000

int f0/0
service-policy output highpolicy

7 replies

Userlevel 4
Hi Tim,

please find below article to convert a Cisco IOS Access-list to Extreme Exos ACL,
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Convert-a-Cisco-IOS-Access-List-for...

Regards,
Naresh.C
Naresh wrote:

Hi Tim,

please find below article to convert a Cisco IOS Access-list to Extreme Exos ACL,
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Convert-a-Cisco-IOS-Access-List-for...

Regards,
Naresh.C

Thank you but not only ACL configuration need to be convert but also the whole QOS configuration, could you please me to translate it?
Userlevel 2
Naresh wrote:

Hi Tim,

please find below article to convert a Cisco IOS Access-list to Extreme Exos ACL,
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Convert-a-Cisco-IOS-Access-List-for...

Regards,
Naresh.C

Maybe this will help?
https://gtacknowledge.extremenetworks.com/articles/How_To/Configuring-QOS-profiles-and-verify-QOS-is...

You can also refer to our user guide to understand how QOS works with EXOS
https://documentation.extremenetworks.com/exos_22.4/EXOS_21_1/QoS/qos.shtml
Userlevel 4
Just type it manually without test, you can have a try in your lab

create meter xxx
configure meter xxx committed-rate 4 Mbps

entry host1 {
if {
source-address 172.30.106.71/32;
}
then {
meter xxx
}}
entry host2 {
if {
source-address 172.30.106.72/32;
}
then {
meter xxx
}}

configure access-list xxx ports xxx egress
Userlevel 4
Steven Lin wrote:

Just type it manually without test, you can have a try in your lab

create meter xxx
configure meter xxx committed-rate 4 Mbps

entry host1 {
if {
source-address 172.30.106.71/32;
}
then {
meter xxx
}}
entry host2 {
if {
source-address 172.30.106.72/32;
}
then {
meter xxx
}}

configure access-list xxx ports xxx egress

BTW, There is a hardware limit for apply meter to egress traffic using ACL on BlackDiamond c-, xl-, and xm-series modules, Summit X480, X460, X670, and X770 series switches, and the E4G400 router.
Thank you all for help! Let me test it.
Userlevel 4
Also see this very useful CLI cross-reference guide. It includes EXOS, Cisco IOS, EOS, VOSS, and BOSS:
https://documentation.extremenetworks.com/CLI_X-Ref/1.0/CLI_X-Ref_Guide_1.0.pdf

Reply