Header Only - DO NOT REMOVE - Extreme Networks

Error: active partitions must be the same across the stack


Userlevel 1
Hello Team,

I want to upgrade stack switches X440, X460 an X250, but at download image appear this error

Error: active partitions must be the same across the stack

How can i do to install the image. Thaks.

[/code]

3 replies

Userlevel 4
you should be a male have some basic IT knowledge
Userlevel 1
This might help: https://gtacknowledge.extremenetworks.com/articles/Solution/Error-When-Attempting-To-Install-A-New-I...

Also, no need for that kind of comment Nick...
Userlevel 7
BigRic wrote:

This might help: https://gtacknowledge.extremenetworks.com/articles/Solution/Error-When-Attempting-To-Install-A-New-I...

Also, no need for that kind of comment Nick...

It has been removed.
Userlevel 5
Hello Susana

I think that gtacknowledge article which BigRic referenced will help you.

Just for your information about upgrading the software on the stack

To run the upgraded software, you must reboot the stack after installation with the image partition that received the software being selected.

If both primary and secondary partitions have the same ExtremeXOS release, you may use the following commands to cause a node to use the same active image as the rest of the stack:use image {primary | secondary} slot slot-number

reboot slot slot-number

If you are using the primary image on your master node and some other node primary image does not contain the same ExtremeXOS version as your master node's primary image, you may use the command: synchronize slot slotid to cause the node to contain the same ExtremeXOS versions in both partitions as it is on the master node, and to reboot the node into the primary partition.

http://documentation.extremenetworks.com/exos_22.2/exos_21_1/stacking/t_upgrade-the-software-on-all-...

Best regards

Reply