Question

Hoe to determine which SFP GBIC is installed in a X650?


I'm trying to determine what model of GBIC is installed into one of the SFP port in X650 switch? I read somewhere that you can view this info via the HAL.

5 replies

debug hal show optic-info slot 1 (if switch is stacked)

If port is in Another slot you ,ust Telnet into the actual slot and run the command.

You will get info of all ports.
Userlevel 4
* X150-24p.4 # debug hal show optic port 25
Port 25
SFP or SFP+: SFP
Signal: present
TX Fault: no
SFP/SFP+ Vendor: Molex Inc.
SFP/SFP+ Part Number: 74741-0001
SFP/SFP+ Serial Number: 52001807
SFP/SFP+ Manufacture Date: 050720
SFP/SFP+ Type: SFP
Connector: Unknown
GE Compliance: 1000BASE-T
Wavelength: 0
Userlevel 1
show ports 5:1 transceiver information detail
Port : 5:1
Media Type : XFP_SR
Part Number : TRF2001EN-GA170
Serial Number : 1104A-xxxxx

Temp (Celsius) : 28.70
Low Warn Threshold : -5.00 High Warn Threshold : 85.00
Low Alarm Threshold : -10.00 High Alarm Threshold : 90.00
Status : Normal

Tx Power (dBm) : -2.23
Low Warn Threshold : -7.30 High Warn Threshold : -1.30
Low Alarm Threshold : -7.80 High Alarm Threshold : -0.80
Status : Normal

Rx Power (dBm) : -2.58
Low Warn Threshold : -9.90 High Warn Threshold : -1.00
Low Alarm Threshold : -10.40 High Alarm Threshold : -0.50
Status : Normal

Tx Bias Current (mA) : 5.48
Low Warn Threshold : 3.00 High Warn Threshold : 12.00
Low Alarm Threshold : 2.00 High Alarm Threshold : 13.00
Status : Normal

Voltage AUX-1/Vcc (Volts) : 3.33
Low Warn Threshold : 3.13 High Warn Threshold : 3.46
Low Alarm Threshold : 3.07 High Alarm Threshold : 3.53
Status : Normal

Voltage AUX-2 (Volts) : N/A
Low Warn Threshold : N/A High Warn Threshold : N/A
Low Alarm Threshold : N/A High Alarm Threshold : N/A
Status : N/A
Userlevel 4
Note:
This needs to be a 1000T transceiver or DDMI is not supported
# debug hal show optic-info slot 1

This worked gave the info I needed, Thanks.

Reply