Header Only - DO NOT REMOVE - Extreme Networks

How i configure LACP between Extreme and CISCO?


Userlevel 1
Hi, I need configure LACP protocol between Extreme and cisco.

i have a BD-8810 SW i need configure two ports with LACP protocol but i dont have idea... the other equipment is a Cisco. i check in the command reference guide but that not say a lot

5 replies

enable sharing grouping lacp (EXOS) Cisco: interface GigabitEthernet0/0/1 no ip address no negotiation auto channel-group 1 mode active end L3-UC#show run int gig 0/0/2 Building configuration... Current configuration : 103 bytes ! interface GigabitEthernet0/0/2 no ip address no negotiation auto channel-group 1 mode active end [/code]
Userlevel 1
Jeremy Gibbs wrote:

enable sharing grouping lacp (EXOS) Cisco: interface GigabitEthernet0/0/1 no ip address no negotiation auto channel-group 1 mode active end L3-UC#show run int gig 0/0/2 Building configuration... Current configuration : 103 bytes ! interface GigabitEthernet0/0/2 no ip address no negotiation auto channel-group 1 mode active end [/code]

Hi Jeremy, so only i need apply this in my BD-8810. for example:

enable sharing 1:2 grouping 1:2 1:3 lacp

but which is the difference with

enable sharing 1:2 grouping 1:2 1: algorithm address-based L3 lacp
Check this guide for basic configuration in EXOS: http://packetflow.io/2015/01/extreme-networks-exos-cheat-sheet.html
Userlevel 7
Hi Daniel,

In addition to what Jeremy and Bernardo posted, this GTAC Knowledge article may help out as well:
https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...

-Brandon
Here is also a great article about Cisco and "port-channels"

http://www.freeccnaworkbook.com/workbooks/ccna/configuring-etherchannel-utilizing-lacp

Reply