How to create an LACP LAG on EXOS 21.1X?


I'd like to create a simple 4 port LAG between an Extreme Switch (x460-G2) and a Brocade switch (that is already successfully setup for LACP)

I've never setup a LACP LAG on EXOS before. Is there a guide for this?

3 replies

Userlevel 6
Hello Sean,

You follow the same procedure to create a lag and add "LACP" onto the end. Here is an article that shows this process:

https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...

Hope this helps!
Userlevel 2
Sean,
you can do this with the following command:

configure sharing grouping algorithm port-based lacp

additional information for this can be found here:
https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...
Userlevel 5
Hi Sean,
Kindly share the good discussion about this topic in our Hub.

https://community.extremenetworks.com/extreme/topics/how-i-configure-lacp-between-extreme-and-cisco

Best regards

Reply