How to disable a port in sharing


Userlevel 1
Hi All

How can I remove a particular port once it is configured as sharing?

Suppose the following is the command saved in switch.

“enable sharing 1:24 grouping 1:24,3:24,6:24 algorithm address-based L2 lacp”



Now I need to remove 6:24 from the following command. Is it possible if so I kindly request somebody to suggest me the command for the same.

5 replies

Userlevel 6
Hi Abdul, please use the command below:

configure sharing 1:24 delete ports 6:24
Userlevel 6
Henrique wrote:

Hi Abdul, please use the command below:

configure sharing 1:24 delete ports 6:24

If you want to add a port to an existing LAG you can use the command below:

configure sharing add ports

You can find these information in the articles below :

https://gtacknowledge.extremenetworks.com/articles/Q_A/Can-I-add-ports-to-an-existing-share-group-without-loosing-configuration

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-create-or-delete-a-share-group-in-EXOS
Userlevel 1
Henrique wrote:

Hi Abdul, please use the command below:

configure sharing 1:24 delete ports 6:24

Dear Henrique

Thank you very much for your quick support. It was realy helpul.

Thanks & Regards
Abdul Raheem
Userlevel 5
Hi Abdul,

The command would be

configure sharing 1:24 delete port 6:24 [/code]Thanks
Brad
Userlevel 1
Dear Parker

Thank you very much for your quick support. It was realy helpul.

Thanks & Regards
Abdul Raheem

Reply