Inter-VLAN Routing not working correctly



Show first post

51 replies

Statically configured IPs seem to route correctly but clients needing a DHCP response seem to not get it. The VLAN and bootprelay seem to be configured properly so I would check the dhcp server to make sure it is still serving addresses for 192.168.11.0/24. If possible, I'd run a tcpdump on the DHCP server and check for DHCP Request packets coming from 192.168.11.1 and if so, does the server send a DCHP ACK packet back. If the server has a log file then check it. If that works then the DHCP server is not the issue and you know that bootprelay is not the issue. If the packet never arrives then it still something with the configuration. VLAN Interface with name VLAN11 created by user
Admin State: Enabled Tagging: 802.1Q Tag 11
Description: None
Virtual router: VR-Default
IPv4 Forwarding: Enabled
Primary IP : 192.168.11.1/24
IPv6 Forwarding: Disabled
IPv6: None
STPD: None
Protocol: Match all unfiltered protocols
Loopback: Disabled
NetLogin: Disabled
QosProfile: None configured
Egress Rate Limit Designated Port: None configured
Flood Rate Limit QosProfile: None configured
Ports: 5. (Number of active ports=5)
Untag: *1:41, *2:13, *2:21, *2:30, *3:7
Flags: (*) Active, (!) Disabled, (g) Load Sharing port
(b) Port blocked on the vlan, (m) Mac-Based port
(a) Egress traffic allowed for NetLogin
(u) Egress traffic unallowed for NetLogin
(t) Translate VLAN tag for Private-VLAN
(s) Private-VLAN System Port, (L) Loopback port
(e) Private-VLAN End Point Port
(x) VMAN Tag Translated port
(G) Multi-switch LAG Group port

Reply