Question

rc operation failed


Summit x460-48p on 15.3.2.11 getting some strange errors that I have never seen before.

vrId 2 adj 0x0A3C482F Add had mixed results. 1 units succeeded, 1 failed (rc Operation failed) flags 0x8000

I was not able to find any information on this error so any help would be appreciated.

3 replies

Userlevel 7
Hi Todd,
Can you provide the output of the command:
code:
show iproute reserved-entries statistics

If you could, please use the "pre" button when pasting it in so that the formatting will be preserved.

Just for reference, the hex of 0x0A3C482F equates to an IP address, in this case it is 10.60.72.47.

Thanks,
-Drew
|-----In HW Route Table----| |--In HW L3 Hash Table--| # Used Routes # IPv4 Hosts IPv4 IPv4 IPv6 IPv4 Slot Type IPv4 IPv6 Local Remote Local Rem. Loc. MCast ---- ---------------- ------ ------ ------ ------ ----- ----- ---- ----- 1 X460-48p 42 0 48 0 846 0 0 8 Theoretical maximum for each resource type: X440 32 16 64 64 509 512 256 * 256 "e"-series 480 240 512 512 2045 2048 1024 * 2048 "a"-series 12256 6128 8189 12288 8189 8192 4096 * 5000 X650, E4G-200 12256 6128 8189 12288 8189 8192 4096 * 6000 X460, E4G-400 12256 6128 12288 12288 16381 16384 8192 * 6000 X670-48x, X670V-48x 16352 8176 8189 16384 8189 8192 4096 * 4096 X670V-48t 16352 8176 16381 16384 16381 16384 8192 * 6000 X480(40G4X) 16352 8176 8189 16384 8189 8192 4096 * 4096 X480 262112 8192 16381 40960 16381 16384 8192 * 6000
[/code]
Userlevel 4
The hardware table is not full.
I would prefer tracing the Ip address and traffic pattern .[VRRP ip ?]
I would also check how often we are seeing these messages in the logs.
This would have been fixed in latest patch.

Reply