Question

Slot-2: Unable to Add L2 2:4 to s,G,v=ac12090c,e0000005,510 IPMC 13, unit 0 Entry not found


Finding subjected error in BD-8806/15.3.3.5 p1-4.
Can someone help me understanding and resolving these error messages, its flooding log message space too.

11 replies

You should reach out to the Gtac and open a ticket
Thanks Jason !
Do you think these messages could be service impacting ?

BR//
Hardik
Userlevel 4
I am searching the database since I have been here today and will get back to you
Userlevel 4
Could you send in a configuration or even the full log?
Userlevel 4
This log messages appear when there is mismatch between the h/w and s/w entries. When certain traffic comes to switch and if H/W entry is not present then that traffic would be process by CPU.
Hi Sumit,
Thanks for your reply, I know "debug hal..." command will get hardware entry. what is the way to find s/w entries ?

BR//
Hardik
Userlevel 4
"debug hal..." will not show the h/w entries.
You need to contact GTAC to report this issue.
Userlevel 4
debug hal show fdb may help
Userlevel 4
Please contact the GTAC as Tokle has stated so we can get to the bottom of the issue.
Hello guys, i'm having the same problem in network, where i work.

Anybody have a solution for the problem?
Userlevel 7
Thiago Ferreira wrote:

Hello guys, i'm having the same problem in network, where i work.

Anybody have a solution for the problem?

Hi Thiago,
There are a few causes for this particular problem. As suggested above, I would recommend opening a case with GTAC so they can help point you in the right direction. The most likely recommendation will be a software upgrade.

You can open a case online, or via phone: http://www.extremenetworks.com/support

-Drew

Reply