Question

Unable to save the configuration in Extreme X250e-48p stack switch.


Unable to save the configuration in Extreme X250e-48p stack switch. Its giving the below error while saving.

(Stack.7 # save

The configuration file primary.cfg already exists.

Do you want to save configuration to primary.cfg and overwrite it? (y/N) Yes

Saving configuration on master .............................. done!

Synchronizing configuration to backup ........... done!

error while tarring/zipping config, config could not be saved on Standbys!)

5 replies

Userlevel 2
As far as i know the config is held by the master switch in the stack 🙂
Userlevel 6
Hello Sowjanya I have not seen this error before. Can you please open a case with GTAC?

How many switches are in the stack?

Thanks
P
Paul Russo wrote:

Hello Sowjanya I have not seen this error before. Can you please open a case with GTAC?

How many switches are in the stack?

Thanks
P

Hi Paul,

There are 3 switches in the stack..

Image running in the device is ExtremeXOS version 12.5.1.6
Userlevel 7
Config is also copied to the backup in a stack. As Paul suggested, please open a case with GTAC, that can be a corrupted CF, or something...
Userlevel 6
thanks Sowjanya GTAC will need to look at the Show Tech to see what might be going on. As Stephane said this could range from a corrupt config to low memory to something else.

GTAC is really the best approach to getting it resolved.

Thanks
P

Reply