Header Only - DO NOT REMOVE - Extreme Networks


  • 20 August 2019
  • 0 replies

UPM profile is launch if one or port event (PortlinkstateUp) is caused.
UPM profile set standard var (related just to UPM profile, so Param_0,Param_1 extc,exct...
Question is:
Is possible read the port(s) status and fix these as variable and then use it in the Upm's script?
If yes, where I can take the value/parameters about their state?

I need to make an expression in wich condition is:
If port A,B,C, status is Up, than enable port D

Of course UPM filter is setted onto just Port A,B,C (for launch the Upm profile)

0 replies

Be the first to reply!