Header Only - DO NOT REMOVE - Extreme Networks

Vlan Graphing


Hi All,

We have just replaced a few Cisco Switches with Extreme Switches, with the Cisco switches we could graph each vlan on the switch. I just would like to understand if this is possible with Extreme, we have configure ports x:xx monitor vlan yyyy, so the data is there. Just need the correct MIB id.

Thanks
Ian

7 replies

Userlevel 6
Ian,

What do you mean by graphing each vlan on the switch? Are you looking for a MIB that shows you the vlans on the switch? Help me understand, I'm sure we can help out.
Hi

I would like to graph the amount traffic for each vlan on the switch, does this help.

Best Regards
Ian
Userlevel 6
Yep. You need to enable VLAN monitoring on the VLANs you want to graph.

configure ports all monitor vlan [/code]
Then you can see the VLAN stats with the below commands.

show vlan statistics no-refresh [/code]
Depending on the VLAN tags and everything the OID's will be different per vlan. With the below OUIs you can just do a SNMP "get next" to find the correct vlans. The numbers will match the command "show vlan statistics no-refresh"

Name extremePortVlanTotalReceivedFramesCounter
OID .1.3.6.1.4.1.1916.1.2.8.2.1.8

Name extremePortVlanTotalTransmittedFramesCounter

OID .1.3.6.1.4.1.1916.1.2.8.2.1.13
Userlevel 6
You can get the VLAN indexes with a "get bulk" on this OID. .1.3.6.1.4.1.1916.1.2.8.2.1.2 but make sure you're on EXOS 15.6.2.12-patch1-2, 15.7.2 or 16.1 and higher per this KCS article.

https://gtacknowledge.extremenetworks.com/articles/Solution/Problem-with-downloading-vlan-counters-f...
Hi Stephan,

Thanks for the reply, we will upgrade the XOS and provide feedback.

Ian
Hi !
I am using s3 chassis with is posible to graph utilization in a interface vlan ?

B O N D E D S 3 - A C H A S S I S
Command Line Interface

Extreme Networks, Inc.
145 Rio Robles
San Jose, CA 95134
Phone: +1 408 579-2800
E-mail: support@extremenetworks.com
WWW: http://www.extremenetworks.com

(c) Copyright Extreme Networks, Inc. 2015

Chassis Serial Number: xxxxxxxxx
Chassis Firmware Revision: 08.32.02.0008
Userlevel 7
Edwin Candelario wrote:

Hi !
I am using s3 chassis with is posible to graph utilization in a interface vlan ?

B O N D E D S 3 - A C H A S S I S
Command Line Interface

Extreme Networks, Inc.
145 Rio Robles
San Jose, CA 95134
Phone: +1 408 579-2800
E-mail: support@extremenetworks.com
WWW: http://www.extremenetworks.com

(c) Copyright Extreme Networks, Inc. 2015

Chassis Serial Number: xxxxxxxxx
Chassis Firmware Revision: 08.32.02.0008

Hi Edwin, I've split this out into its own thread for better visibility. -Brandon Please reference the new conversation here: VLAN Utilization Graphing via SNMP

Reply