what is the command to enable the web browser connection to a switch?


I have one switch that I'm able to connect to web browser and others that I can't.

I'm looking for the command that should run in the others switch to enable the Browser connection.

Thanks

10 replies

Userlevel 6
enable web http

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-enable-the-web-interface/
Userlevel 7
Hi Bernard,
Assuming you're talking about an EXOS switch, the command you're looking for is
code:
enable web http

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-enable-the-web-interface/

Depending on EXOS version, you may get ScreenPlay or Chalet.
https://gtacknowledge.extremenetworks.com/articles/Q_A/Which-EXOS-version-is-required-for-Extreme-switches-in-order-to-use-Chalet
thanks it's works fine for Summit x250-48t.
but not working for Summit 200-24, do you know the command for this model?
Userlevel 7
Hi Bernard,
It looks like the
code:
enable web http
command for ExtremeWare devices was added for the Summit e series in v7.3. What version are you running on the S200-24?
System Serial Number: 800105-00-07 0447G-02101 CP:04
Image : Extremeware Version 7.8e.4.1 [non-ssh] by Build_Master on 03/18/11 04:1
1:31

BootROM : 5.1
Userlevel 7
That switch and version should support this feature. Since the S200 is End-of-Life, I don't have one readily available to test with in our lab.
Let me see if I can get one online again to confirm.
Userlevel 7
Found the issue... per the release notes:
Enabling HTTP on a Non-SSH ExtremeWare 7.4 or Later Image
In ExtremeWare 7.3, the CLI command syntax used to enable HTTP is
code:
enable web http
even when upgrading a non-ssh image. In ExtremeWare 7.4, the
code:
enable web
command is used with the option
code:
http
/
code:
https
. This command option is only available with the ssh image. Therefore, when upgrading an ExtremeWare 7.3 non-ssh configuration to an ExtremeWare 7.4 non-ssh configuration, the
code:
enable web http
command will fail.

Let's get your switch upgraded and SSH capable. Here's the SSH Image Request Form for ExtremeWare 7.8.4-patch1-4 (the latest available).
https://extrwebapps.extremenetworks.com/WebApps/Public/ExportControl/?swID=112
The file you want from the download is
code:
v784b1-patch1-4.SFxtr


I went ahead and gathered the Release Notes for you too: http://tech.extremenetworks.com/ftp/ftp_new.aspx?file=ExtremeWare 7.8.4b1-patch1-4_RelNote.pdf
Let me know if you need anything else!
Userlevel 7
And you'd check whether it's enabled/disabled with ...

X430-48t.3 # show management
Userlevel 6
Drew, I think this one wins for the fastest answered question with 3 responses. Ha
Userlevel 7
Stephen Williams wrote:

Drew, I think this one wins for the fastest answered question with 3 responses. Ha

I think so! Welcome to The Hub, Bernard!

Reply