Header Only - DO NOT REMOVE - Extreme Networks

X440-48p switch does not boot till unplug and plug the power cable


Userlevel 2
I have a setup of more than 100 X440-48p switchs firmware 15.6.4.2.

There are two switches which (if the power cut off and return back) do not boot till unplug and plug the power cable.

Is there any advice!

Thanks in advance.

2 replies

Userlevel 6
Hi Husam,

I would suggest to open up a ticket with GTAC on the same, you can provide the "show tech" for initial analysis.
Userlevel 6
Wow....thanks for deploying 100+ Summit X440(s) Husam!

GTAC will help you get to the bottom of this.

Reply